Locate the Reset pin hole on the rear panel of the Unleashed Master AP. Insert a straightened paper clip in the hole and press for at least 6 seconds. After the reset is complete, the PWR LED will initially be solid red, indicating bootup in process, then blinks green, indicating that the system is in factory default state.
10/13/2015 · If you have physical access to the ZD, then you can do a hard reset on it directly by holding the F/D pinhole for 12 to 15 seconds. After the reset is done, the Status LED blinks red, then blinks green, indicating that the system is in factory default state. You can access it on the default IP 192.168.0.2 -.
In certain extreme conditions, you may want to re-initialize ZoneDirector and reset it to factory default state. In this state, the network is almost ready for use, but all your user/guest/log and other records, accounts and preference configurations would need to be manually reconfigured.
Locate the Reset pin hole on the rear panel of the Unleashed Master AP. Insert a straightened paper clip in the hole and press for at least 6 seconds. After the reset is complete, the PWR LED will initially be solid red, indicating bootup in process, then blinks green, indicating that the system is in factory default state.
Press and hold the reset button and apply power to the switch. Release the reset button after all of the system LEDs flash amber. When all the system LEDs blink green, all the configuration data is being erased and the switch is returned to its factory configuration.
F/D button for at least five (5) seconds. For more information, refer to Alternate Factory Default Reset Method. WARNING: Resetting ZoneDirector to factory default settings will erase all configuration changes that you have made, except for AP licenses and SSL certificates. Ruckus Wireless, Inc.
